A talented auto repair professional can set up a Chrysler LHS fuel pump in about an hour. The Chrysler LHS fuel pump mounts to the highest of the fuel tank, positioned underneath the rear of the automobile. The placement of the pump is strategic–it permits the physique of the pump to hold down into the gasoline contained in the tank and is used to chill and lubricate itself. The pump attracts gasoline up and out of the tank and sends the gasoline ahead to the LHS’s fuel injectors, situated atop the engine.
Chrysler LHS Fuel Pump Installation Instructions
1. Open the LHS’s hood by hand. Unhook the negative battery cable the place it meets the battery utilizing the battery wrench.
2. Shove the wheel chocks in opposition to the front and rear of the left-front tire to stop the LHS from rolling. Elevate the LHS’s again finish off the bottom with the ground jack. Place a jack stand beneath the rear physique rail elevate level, positioned simply in front of the rear wheel wells. Decrease the LHS onto the jack stands with the ground jack.
3. Manually transfer the ground jack beneath the fuel tank. Carry the jack head up till it contacts the underside of the fuel tank. Unbolt the 2 fuel tank retaining bands utilizing a socket set.
4. Decrease the fuel tank a number of inches to permit your self room to achieve between the tank and the LHS’s floorboard. Your objective is to disconnect the fuel strains and fuel pump wiring harness from the fuel pump utilizing your fingers.
5. Carry the gasoline tank down fully with the ground jack. Pull the jack and tank out from beneath the LHS by hand. Choose up the fuel tank, transfer it off the jack and set it on the bottom.
6. Place a rag over the tip of the screwdriver after which place the screwdriver tip towards the vertical fringe of the fuel pump retainer ring. Faucet the deal with of the screwdriver with the rubber mallet to spin the ring counterclockwise.
7. Carry the outdated gas pump out of the LHS’s fuel tank by hand. Set it apart. Decrease the brand new fuel pump into the tank. Be sure that you simply orient the fuel pump sender float ready that permits it to maneuver freely contained in the tank.
8. Flip the fuel pump retainer ring clockwise to lock the fuel pump in place. Return the fuel tank to the ground jack and roll them each again beneath the LHS.
9. Reverse the way in which you put in the fuel tank and reinstall. Decrease the LHS off the jack stands together with your ground jack. Rehook the battery cable to the battery and shut the hood.
10. Flip the ignition key to the run position for ten seconds; it will prime the fuel system earlier than beginning the automobile. It might be essential to repeat this step earlier than the LHS will begin.
Read more : How to Install a Chrysler LHS Fuel Pump